Farmi Forest VALBY CH140 L, Эксплуатация, техническое обслуживание и запасные части

Страница: 25 / 40

CH140 L
25
9.5.3.SHARPENING THE ANVIL
If you notice wear or rounding of the inner edge of the anvil, sharpen the anvil so that original angles are retained.
9.6.TIGHTENING THE BOLTS
D
The tightness of fasteners and the bolts in the chipper must be checked once a week. IMPORTANT! On a new
machine check the tightening after one hour of use.
D
Refer to Maintenance and lubrication schedule, chapter NO TAG Tighten as indicated in the specifications below.
3
2
1
4
5
Fig.25..
9.6.1.TORQUES AND CLEARANCES
ITEM Socket size Torque, Nm (lbf)
1 , Check knife bolts tightness 17mm (11/16”) 60 (44
3
/
16
)
2 , Check bearing housing bolts tightness on
both sides
19mm (3/4”) 80 (58
15
/
16
)
3, Check anvil bolts tightness 24mm (15/16”) 200 (147
3
/
8
)
ITEM Socket size Measurement
4 , Check clearance between knives and anvil 19mm (3/4”) 1,2--1,5 mm (0.05 -- 0.06”)
5. Check bearing’s radial clearance
0.02---0.03 mm
(0.0008” to 0.0012”)