Manual
TRITON 450 PS
22
│
30
Checking the nuts on the transport axle
Use the plastic arrow “Check Point” to check for loose nuts. It promptly shows the condition of the
nuts, whether they are loose or not.
Always check the Check Points before driving.
When the arrows are not facing one another, the nuts have to be tightened to the required torque and the
Check Point arrows have to point against one another as shown in the green picture.
Torque for the axle nuts:
M18x1,5 - 265Nm
M20x1,5 - 343Nm
M22x1,5 - 440Nm
Ban of transport with decreased visibility!
Bring the machine into the transport position.
The operator is obliged to pay increased attention during transport on roads, due to the transport
dimensions of the machine.
The operator must observe the valid regulations for transport on roads (laws, decrees) after connecting the
machine to the tractor, for reason of a change of the axle load. The driving properties of the set also
change depending on the terrain nature, adapt the manner of driving to these conditions.
The operator is obliged to present the machine certificate of roadworthiness as needed, according to the
valid regulations for road traffic (decree, law) (only in the Czech Republic).
The operator is obliged to secure sufficient outlook during reversing from his position of the tractor
driver. In case of insufficient outlook, the operator is obliged to call a competent and informed person.
The operator must fold the side frames for transport and secure then against unwanted unfolding by
disconnecting the hydraulic circuit of the machine and the tractor.
During machine transport on roads, the operator must observe the valid laws and decrees that deal with
this topic and which specify the relationships of the tractor axle load depending on transport speed.
