Farmet TRIOLENT TX 380 NS, Руководство по эксплуатации

Страница: 20 / 34

COMMISSIONING
8.1 Agregation to a tractor
• The machine can be connected only to a tractor, whose curb weight is identical or higher than
the overall weight of the connected machine.
• The machine operator must observe all generally valid regulations of work safety, health
protection, fire safety, and environmental protection.
• The operator may connect the machine exclusively to a tractor that is equipped with a rear
three-point suspension and a functional undamaged hydraulic system.
• The table of requirements for the towing means for work with the machine:
Requirement for the tractor engine power for cultivator TX 380 NS 150-260 kW* (200 - 350 HP)*
Requirement for the tractor engine power for cultivator TX 470 NS 190-330 kW* (255 - 445 HP)*
Requirement for
the tractor's TPS
Spacing of the lower
suspension joints (measured
at the joint axes) TPS3
1100+/- 1,5 mm (43,3 in)
KIROVEC
1110+/- 1,5 mm (43,7 in)
ø of the hole of the lower
suspension joints for the
machine suspension pivots
TPS3
37,4 - 37,75 mm (1,472 – 1,486
in)
KIROVEC
60,5 – 61 mm (2,38 - 2,40 in)
ø of the hole of the upper
suspension joint for the
machine suspension pivot TPS3
32,0 – 32,25 mm (1,26 – 1,27 in)
KIROVEC 39,5 - 40 mm (1,55 – 1,57 in)
Requirement for
the tractor's
hydraulic system
Side frame folding circuit Circuit pressure 200bar (2900
Psi), 2 pcs of quick-coupler
sockets ISO 12,5
* Recommended towing means, the real towing force may significantly vary according to the processing
depth, soil conditions, land slope, working body wear and adjustment
• Connect the machine using the TPS suspension bar to the lower arms of the rear TPS of the
tractor, secure the TPS arms using pins against disconnecting.
• The machine aggregated with the tractor changes the distribution of the weight to the
individual axles of the tractor. The weight of the front axle is reduced and therefore the
controllability gets worse. It also affects braking properties.
When connecting, no persons may stay in the space between the tractor and the machine.
8.2 Hydraulics connection
• Connect the hydraulics only when the hydraulic circuits of the machine and the tractor
(aggregate) are in a pressure-less condition.
• The hydraulic system is under high pressure. Regularly check for leaks and immediately remove
obvious damage of all lines, hoses, and pipe unions.
• When seeking and removing leaks, use only the suitable tools.
• For connecting the hydraulic system of the machine to the tractor, use the plug (on the
machine) and the socket (on the tractor) of the quick-couplers of the same type. Perform the
connection of the quick-couplers of the machine to the hydraulic circuits of the tractor so that
the folding of the side frames (
BLUE and WHITE DUST CAP) is on one control circuit.
In order to prevent accidental or foreign person (children, passengers) caused movement of the
hydraulics, the control switchboards on the tractor must be secured or blocked in the transport
position.
20 | 34