Farmet DG3N, Руководство по эксплуатации

Страница: 26 / 35

26 | 35
MACHINE ADJUSTMENT
10 MACHINE ADJUSTMENT
10.1 Working tools setting
• The operators may only adjust the working tools of the machine when in a standstill, i.e. when
the machine is not working and it is secured from movement.
• The operators must only execute the adjustment of the working tools of the machine on an
even and reinforced surface for even soil processing.
• The Depth Loosener is to be coupled using the three-point suspension in an usual way. The
lower arms of the hydraulics must be at the same level if measured from the ground. The
working depth of the shares is within the range from 50 to 60 cm (X) (Fig. 5).
10.2 Adjusting the working depth of the shares
TRACTORS PROVIDED WITH POSITION HYDRAULICS
• Use the arms of the tractor hydraulic system to adjust the required working depth of the shares. When
sinking the shares repeatedly, the control lever should be put into the same position (stop). To finish the
setting, adjust the third-point pull rod in such a manner that the frame of the machine in the working
position is vertical to the ground (Fig. 5).
TRACTORS PROVIDED WITH FLOATING AND POWER HYDRAULICS
• With these types of tractors, the sinking is to be set by adjusting the length of the tractor's third-point
pull rod and by adjusting the copying wheels position. The frame of the machine must be vertical to the
ground (Fig. 5).
Fig. 5 - Working tolls setting
1 – Third-point pull rod
2 – Copying wheels adjusting screws
3 – Copying wheels
4 – Tractor's hydraulics arms