FarmChem APX DPM10G, Руководство пользователя

Страница: 9 / 16

FarmChem | www.FarmChem.com 800.247.1854 | FarmChem
9
C-2 Value Setting
The meter allows the operator to store
five different PRESET values (AUTO 1 ...
AUTO 5), which can be recalled with -
out having to set them each time with
numeric keys.
Press and hold OK/STOP once to set
the function.
The meter will display:
Blinking
Index of the PRESET value AUTO 1
When the value is blinking, press AUTO
to select preset 1-4, then press the
numeric buttons to set the value.
Blinking message will be:
Press RESET to confirm the value and
quit the setting mode. The setting value
will be stored.
By holding on the keys, the value con -
tinues to vary.
C-3 Unit Setting
The meter allows the user to select one
of the following measurement units:
• QTS = QUARTS
• PTS = PINTS
• LIT = LITERS
• GAL = GALLONS (U.S. Gallons)
Press and hold OK/STOP two times to
set the function.
The meter displays:
When the unit is blinking press AUTO to
select unit L, GAL, PT or QT.
Press RESET to confirm the value and
quit the setting mode, the setting value
will be stored.
NOTE: The above mentioned mea -
surement units refer to the Batch total
indicators
• If you select the unit LITERS, the
TOTALS will be displayed in LITERS
• If you select the unit GALLONS,
PINTS or QUARTS, the TOTALS will be
displayed in GALLONS
• The modification of the measure -
ment unit does NOT require a new
calibration
• If the TOTAL indicates a value oth -
er than zero, this value is automat -
ically converted from one unit to
another unit
Attention: In order to preserve the unit
setting, OK/STOP must be held for two
seconds after accomplishing setting
and the program will be saved until
the start of the next function setting. If
it is necessary to preserve the setting in
flash in case of power-off, wait for 30
seconds until the screen disappears.
The setting will be written in flash then.