FarmChem APX DPM10G, Руководство пользователя

Страница: 10 / 16

FarmChem | www.FarmChem.com
10
C-4. Decimal Digits Setting
Press and hold OK/STOP three times to
set the function.
The meter will display:
Blinking point
When the number point is blinking,
press AUTO to select the location of the
point to confirm the number of deci -
mal digits setting.
Press RESET to confirm the value and
quit the setting mode. The setting value
will be stored.
NOTE:
• The meter displays the FLOATING
POINT Batch total dispensed
• Independent of the selection
carried out (two or three decimal
digits), as soon as the amount
dispensed exceeds 10 units, the
meter displays only two decimal
digits
• As soon as the amount dispensed
exceeds 99 units, the meter dis -
plays only one decimal digit
C-5 Reset Setting
Press and hold OK/STOP four times to
set the function.
The meter displays:
Blinking
When YES is blinking, press AUTO to
select YES or NO. If YES, the batch total
will be set to zero after hold OK/STOP
button for 10 seconds, NO to cancel.
Press RESET to confirm the value and
quit the setting mode. The setting value
will be stored.
NOTE: Independent of the selection
carried out, the Batch total supplied is
never reset if the dispensing operation
has been carried out in AUTO mode
C-6. Auto Reset Setting
The function described in this paragraph concerns only those who want to obtain
the maximum dispensing stop precision in AUTO mode.
If a slight excess of the pre-set value (a few hundredths of a quart) dos not cause
any problem, the following paragraphs can be ignored.
The meter in AUTO mode allows the user to obtain a highly precise stop, thus dis -
pensing exactly the pre-set amount without exceeding the PRESET value.
To guarantee this high stop precision, especially when the unit operates at the
maximum allowed flow rates, dispensing does not stop when the PRESET value is
reached, but instead when the PRESET value reaches a few Unit hundredths.
To guarantee the stop precision, this pre-stop value must not be fixed, but is de -
pendent on the flow rate used. To allow the operator to obtain the highest stop
precision, the unit is equipped with a Stop Precision factor, or PS factor.
The operator can customize the meter to select a PS factor between ZERO and
FOUR.