Farm King 1066, Руководство оператора и каталог запасных частей

Страница: 14 / 28

14
Assembly - 1066 & 1076 Conventional Auger
11. Mount the winch (Ref. #49) using the 3/8" x 1" bolt, nut and lockwasher combinations (Ref. #48)
and thread the cable as instructed below.
Fasten the lift cable (Ref. #56) to the tube by the tube splice with a cable thimble and two cable
clamps (Ref. #55). Thread the cable around and through the top sheave in the track car, back
around and through the sheave by the tube splice, back around and through the lower sheave
in the track car and fasten to the winch. The cable must be threaded between the mounting
plate and the cross shaft as shown.
DANGER
Winch must be aligned with cable so that the cable does not stack
on one side of the drum. Do not allow the cable to become slack
on winch drum. The cable may recoil and slip over the side of the
drum. In either case, the cable will wind on drum spindle and
cause the winch or cable to fail, allowing auger to drop, which
may cause physical damage to the auger or may cause personal
injury.
12. Mount the Owner's Manual container tube (Ref. #141) to the winch mount as shown, using 1/4"
x 3/4" bolt, nut and lockwasher combinations and mounting straps (Ref. #142).
13. See separate assembly instructions on the following pages for the different drive packages.