FARGO electronics DTC400e, Руководство пользователя

Страница: 263 / 284

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.0) 9-1
Section 9: Firmware Upgrades
Requirements
•
Windows 32 bit Operating System (2000/XP/2003) Vista (32 bit only)
•
Internet Access
Safety Messages (review carefully)
Symbol Critical Procedures for Safety purposes
Danger: Failure to follow these installation guidelines can result in death or
serious injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the below).
•
To prevent personal injury , refer to the following safety messages
before performing an operation preceded by this symbol.
•
To prevent personal injury , always remove the power cord prior to
performing repair procedures, unless otherwise specified.
•
To prevent personal injury , make sure only qualified personnel
perform these procedures.
Caution: This device is electrostatically sensitive . It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is indicated by
a warning symbol (as shown to the below).
•
To prevent equipment or media damage , refer to the following
safety messages before performing an operation preceded by this
symbol.
•
To prevent equipment or media damage , observe all established
Electrostatic Discharge (ESD) procedures while handling cables in or
near the Circuit Board and Printhead Assemblies.
•
To prevent equipment or media damage , always wear an
appropriate personal grounding device (e.g., a high quality wrist strap
grounded to avoid potential damage).
•
To prevent equipment or media damage , always remove the
Ribbon and Cards from the Printer before making any repairs, unless
otherwise specified.
•
To prevent equipment or media damage , remove jewelry from
fingers and hands, as well as thoroughly clean hands to remove oil
and debris before working on the Printer.