Revisione - 08
Date 01-2012
13
GB
RAC 230
C
D
MIN 300
Ø 8
A
B
MAX 200
HOW TO USE YOUR RIVETING TOOL
(fig.
f1-f2
)
After the clamping, the sheared nail is piped by the riveting tool,
ejected from the back and let fall down by the nail deviator (
A
).
By swinging the valve (
B
) you can adjust the suction power.
By the suction nail system, the rivet remains in the nozzle also
turning over the head of the riveting tool downwards: this detail
increases a lot the usefulness of the riveting tool. Do not keep
the rivet with your fingers!
DO NOT DISPERSE ANY NAIL!
WARNING!!
Do not remove the nail deviator (
A
)
during the riveting operation, as the nail ejection
from the back of the tool can cause damages
to the worker or to persons who are nearby the
work surface.
f2
f1
A
B
RAC 230
RAC 230
If you want to convey the sheared nails into a container, remove
the nail deviator (
A
) and its reducer (
B
) from the riveting tool.
Connect a pipe ø 10 x 8 (
C
) to the riveting tool introducing it
into the union (
D
).
ATTENTION:
the bending radius of the pipe should not be
smaller than 300 mm and it should not be higher than 200
mm compared to the riveting tool, as shown in the picture
f2
.
