FAR RAC 230, Оригинальная инструкция

Страница: 19 / 68

19
GB
RAC 230
750331 - RAC 230 – rev 11 - ( 04-2019 )
A
12 mm
C
B
RAC 230
EAC
TOPPING UP THE OIL-DYNAMIC CIRCUIT (fig. f7 )
you need to top up the oil-dynamic circuit after a long period of work (15000 cycles), when you note a power loss. Proceed as
follows: by means of a short jet of compressed air through hole (
C ) make the piston completely go back, unscrew the screw ( A )
by a 12 mm standard spanner key, extract the seal and continue the oil topping up by means of the oil container ( B ) being part
of the equipment which has preliminarily been filled with hydraulic oil HLP 32 cSt . This operation has to be carried out slowly in
order to enable the air to come out of the tank. The procedure has been fulfilled when the oil level arrives at the threaded port.
Then, fit the o-ring in his seat and tighten the screw (
A ) with a torque of min. 5 Nm to max. 8 Nm . At this point, the topping up
operation has been finished. Screw the riveting tool head ( B ) again on the body ( A ) and continue with the normal work cycle.
WARNING: it is very important to follow the about mentioned instructions and use gloves.If you need to empty fully the hydraulic
circuit, you must put the oil in a suitable container and contact a Company that is authorized to discharge any waste.
ATTENTION!
Before disconnecting the compressed air hose, make sure that it is not under pressure!
ATTENTION: Make sure that the oil filler cap ( A ) is tightened at a torque corresponding to Min. 5 Nm ÷ Max. 8 Nm.
We recommend to use oil HLP 32 cSt or similars.
DISPOSAL OF THE RIVETING TOOL
Follow the prescriptions of the national laws for disposing of the riveting tool.
After disconnecting the tool from the pneumatic system, disassemble and split all the components according
to the material: steel, aluminium, plastic material, etc.
Then proceed to scrap the materials in accordance with current laws.
f7
min. 5 Nm
MAX 8 Nm