Far Tools TDM 400B, Руководство пользователя, Страница: 22 / 40

© FAR GROUP EUROPE
WARNING: Never release lever 2 until the thread cutting is finished
To reset the tool in the start position, reverse the chuck direction and repeat a number of
0.25 mm passes to achieve the final 1.3925 mm dimension, Try the M 20 x 2.5 bolt before
disengaging the centre gage lever 2
The mixed fitting mode is used when the part, once clamped in the chuck, protrudes
from it by more than twice its diameter.
Tighten the part in the chuck, Drill a centre hole using a centring bit, Then bring up
the tailstock centre (114317), the mounting is a rigid one and it is possible to safely ma-
chine.
The fitting between tailstocks mode is used to produce axes that require perfect concen-
tricity between all diameters. To do this, it is necessary to drill a centre hole through both
ends of the axis to be machined. Then take the chuck apart and fit the dry tailstock and
place the part to be milled between the dry tailstock and the spinning one (114317).
Drive is achieved with a toc
MIXED FITTING
FITTING BETWEEN TAILSTOCKS
OTHER MILLING MODES
Metric
threading
114135-Manual-D-EN.indd 22 21/03/12 10:45:00