Far Tools TDM 400B, Руководство пользователя, Страница: 10 / 40

© FAR GROUP EUROPE
PROCEDURE FOR CHANGING GEARS TO ADJUST THE ADVANCE
The advance is set by changing the gears which are located in the cabinet on the left
hand side of the machine and by making reference to the table.
Gear A: 16 mm open end wrench
Gear B: 5 mm Allen wrench
Gear D: 16 mm open end wrench
Gear D adjustment screw: 5 mm Allen
wrench
Choose the advance or increment to be performed, refer back to the table below for the
choice of gears to use. I and II correspond to the No. 3 lever position.
Slacken and remove the nuts from gears A and D using a 16 mm wrench,
Slacken the 6 mm hollow head bolt on gear B using a 5 Allen wrench.
Slacken the 6 mm hollow head bolt used to adjust gear D using a 5 mm Allen wrench.
Remove gears A and D (taking care to not lose the key!),
Take the gears that match the advance or increment to be performed.
Reassembly: Refit gear A and tighten down the 16 mm nut, Adjust gear B in relation to
gear A and tighten down the 6 mm Allen head bolt, Lastly, refit gear D onto gear B by
sliding the support and locking down the 6 mm Allen head bolt
WARNING: Before performing any gear replacement operation, ensure that the power
cable is disconnected.
Transmission box
Unit: mm
I II
24 25 30 60 24 30 60
24 0,8 0,4 0,4 0,2
27 0,45
30 0,5 0,25
36 1,5 0,6 0,75 0,3
42 1,75 0,7 0,35
60 2,5 2 1,25 1
75 3
A
D
114135-Manual-D-EN.indd 10 21/03/12 10:44:52