6
5.2.2
Device connection confirmation
Check whether the power cord and network cable of the device are connected, and whether they
are
normal
after
30
seconds
after
power-on.
(Check
the
network
indicator
status)
Figure 1 - Connection Diagram
5.3 Appendix Table
5.3.1
Common command mode
Table 1 - Common command mode
Action
Description
IP
Broadcast
under
standby
mode
In standby, long press the speed dial key 10, there will be a beep and
the indicator will flash quickly for 5 seconds, 5 seconds
Press the speed dial key once inside, the beep sound stops and the
IP is automatically reported
Switch
network
mode
In the standby mode, press and hold the speed dial button for 10
seconds, there will be a beep and the indicator will flash quickly for 5
seconds.
Within 5 seconds, quickly press the speed dial key three times to
switch the network mode. Network status is static or
PPPoE mode will be switched to DHCP mode; when the network is
DHCP mode, it will be switched to static IP
192.168.1.128, report IP after successful switching
