82
-
Clean it with a metal brush and check that
the distance between the electrodes is 0.5
-0.6 mm.
This should be done approx. once every
1000 km, while the plug must be changed
once every 4000 km.
- Re
fi
t the spark plug, inserting it
fi
rst by
hand and only using the wrench for the
fi
nal tightening.
-
Replace the spark plug cover tube (1), ensur-
ing that it has been inserted correctly.
Whenever the spark plug is changed, check the
pitch and the reach of the thread. If the threaded
part is too short, carbon deposits will build up
on the thread seat thereby risking damaging the
engine when the correct spark plug is refitted.
Only use spark plugs of the recommended type,
see page 85 (SPECIFICATIONS), otherwise en-
gine performance and life could be adversely
affected.
CHANGING THE HEADLAMP BULB
The headlamp houses:
- a position light bulb;
- a dipped/full beam bulb.
ACCESSING THE BULBS
- Place the vehicle on the stand.
-
Release the four lamp-bracket flexible sup-
ports
The lamp bracket complete with headlamp re-
mains connected to the electric cables.
DO NOT
TUG ON THE ELECTRIC CABLES.
To work more comfortably the headlamp
may be detached by loosening the two side
screws.
- Shift the complete lamp bracket to the side.
NOTE:
handle the plastic parts with care; do not
scratch or damage them.
POSITION LIGHT BULB
Do not tug on the electric cables to take out the
lamp-holder.
-
Grasp the lamp-holder and pull it out of its
seat.
-
Take out the position light bulb (1) and re-
place it with one of the same type.
