83
EN
G
LI
SH
DIPPED/FULL BEAM BULB
-
Do not tug on the electric cables to remove
the bulb electric connector.
-
Remove the black rubber sleeve from the
central lamp-holder.
-
Release the lamp-holder retaining spring (3)
and remove it.
-
Draw out the lamp-holder (2) from the pa-
rabola seat.
-
Press the bulb gently and turn it counter-
clockwise.
- Take out the bulb from its seat.
Once the bulb has been changed, just proceed
with the disassembly stages in the reverse order
in order to remount the optical unit.
CLEANING THE VEHICLE AND INACTIVITY
It is a good rule to clean the vehicle periodically
to keep its parts in good condition.
If the vehicle is used in the following conditions,
more frequent washing is recommended:
-
Coastal areas or areas with a hot and humid
climate in which the humidity and salinity in
the atmosphere are higher than normal.
-
Roads or areas where salt or chemical prod-
ucts are used to melt snow and ice.
-
Roads or areas where there are industrial
dusts or patches of tar.
- Sporting use and off-road riding.
-
Presence on the vehicle body of dead in-
sects, bird droppings, etc.
It is advisable not to stop or park the vehicle
under plants or trees. In some seasons certain
plants and trees release residues, resins, fruits
or leaves containing harmful substances (in par-
ticular harmful for the bodywork).
REAR VIEW MIRRORS
The operations described below are
valid for both rear-view mirrors.
Place the vehicle on the stand and on a flat
and stable surface. Loosen the lock nut "A",
turn the mirror counterclockwise and
remove it.
During reassembly, before tightening
the nut, check that the mirror support
rod is aligned with the handlebar.
REAR VIEW MIRRORS ADJUSTMENT
To adjust the rear-view mirrors, steer onto the vehicle in
running position and rotate the mirror according to your
needs. It is also possible to adjust the inclination of the
rear-view mirror support rod. To do this, loosen the
screw "B" and move the support rod sideways. Make
the adjustment and tighten the screw "B".
