FANTEM Oomi MultiSensor, Руководство пользователя

Страница: 15 / 35

Sensor detects movement to control the associated devices to “OPEN”
state. After 4 minutes by default, if the Motion Sensor is not triggered
again, the MultiSensor will send Basic Set Command to these devices
to set them to their “CLOSE” state. However, if the Motion Sensor is
triggered again within 4 minutes, the MultiSensor will reset the timing
and start timing again.
The 4 minutes delay time can be changed through the usage of Z-Wave
commands built into Z-Wave certified controllers/gateways. (The specific
Z-Wave command supporting this function is Configuration Command
Class) Please consult the operation manual for these controllers/
gateways for specific instructions on configuring the MultiSensor.
Parameter 3 [2 byte decimal] can be configured through your gateway
in case the default settings of your MultiSensor are not what you desire.
For example, this parameter setting is initially set to 240 which is the
delay time in 4 minutes or 240 seconds. You may set the value to the
desired Motion Sensor delay time to any amount of seconds as you like.
So if you want the time out to be 5 minutes after the Motion Sensor is
triggered, set this parameter to the value of 300.
Setting the sensitivity of your MultiSensor.
Parameter 4 [1 byte decimal] can be configured through your gateway
in case the default settings of your MultiSensor are not what you desire.
For example, this parameter setting is initially set to 5 which is the
maximum sensitivity level, if you set it to 1, the sensitivity will be the
14