Fantasea Nano LED Pro Set, Руководство оператора

Страница: 4 / 8

4
2. Installing and Removing Batteries
A. Prior to installing batteries, the white cone should be
removed. Simply detach the cone from the flashlight’s
head by gently pulling them away from each other. Make
sure that when separating the cone from the flashlight,
there is no tension exerted on the cone’s lanyard, which is
wrapped around the flashlight.
B. To open the Nano LED Pro, hold the hand grip firmly in one
hand and turn the flashlight head counterclockwise until it
separates. Pull the flashlight head off. Please make sure
that the light is pointed in an upward position so the
contents do not fall out when opened. Take special care
not to stare into the light beam which is very powerful and
could damage your eyes.
C. Gently remove the LED head by pulling it out.
D. Install or remove the 4 AAA Alkaline batteries carefully.
Please note that this light should not be used with
rechargeable batteries. Make sure that you follow the
instructions diagram printed on the inside of the light. Note
that there are two sets of two batteries, each set pointing
in a different direction.
E. Replace the LED head carefully, making sure that the two
protrusions on the inside of the battery compartment
correspond with the two niches on the LED head. This is
the only way it will fit properly.
F. Carefully place the flashlight head over the threads, and
tighten evenly in a clockwise fashion. Do not use force and
do not allow it to screw down unevenly. Take special care
not to stare into the light beam which is very powerful and
could damage your eyes.