13
Maintenance
1.
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed. When cleaning, use
only a soft brush or lint free cloth to avoid
scratching the finish. Abrasive cleaning agents are
not required and should be avoided to prevent
damage to finish.
Do not use water when cleaning your ceiling fan.
It could damage the motor or the finish and create
the possibility of electrical shock.
CAUTION
Periodic light dusting of the blades is recommended.
A feather duster will work best.
How to Clean Your Ceiling Fan Blades
Avoid using water, cleansers, or harsh rags, which
can warp and ruin the finish.
How to Operate Your Ceiling Fan (Continued)
Code Switches
Figure 5
5.
“D” and “ON” dip switch:
The “ON” selection is the light dimmable selection and is to
be used with all bulbs other than CFL. The “D” selection is
the light on only (no dimming function) and is to be used
with CFL bulbs (as CFL bulbs cannot be dimmed). The
receiver provides the following protective function:
(Figure 5)
Lock position: The DC motor has a built-in safety feature
against blade obstruction against obstruction during
operation. If something obstructs the fan blades the motor
will stop operating after 30 seconds of interruption. Please
remove obstacles and reset.
Over 80W protection: When the receiver detects motor
power consumption which is greater than 80W, the
receiver power will shutdown and fan operation will cease.
Disconnect the power supply and after 5 seconds return-
power on to the fan.
How to Replace Receiver
1.
Remove cover housing upper by unscrewing the
two screws. (Figure 1)
2.
Unplug signal wire and 9-pin connector than replace
new receiver. (Figure 2)
3.
Tight the two screws from the cover housing upper.
(Figrue 3)
Figure 1
Cover
Housing
Upper
Figure 2
Figure 3
4.
After installing new receiver to your fan, operate the
remote “Code Setting” process on “How to operate your
ceiling fan” Step 3 again.
Signal Wire
Receiver
9-Pin
Connector