How to Assemble Your Ceiling Fan Blades
How to Install Your Canopy Housing
2.
Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary wiring is completed.
Ceiling Canopy
12
HARDWARE USED:
x 15
x 15
FIBER WASHERS
3/16˝-24
WASHER HEAD
SCREWS
2.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a phillips screwdriver, tighten 3/16˝-24 washer
head screws and fiber washers to secure the blade
to the blade holder. (Figure 2)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
1. Remove and discard the five rubber motor
stops/screws from the motor assembly. (Figure 1)
Figure 1
Blade
Blade Holder
Figure 2
3/16˝-24
Washer Head Screws
and Fiber Washers
(3 each per blade)
Canopy Screw
Cover
Figure 2
Motor Stops
Motor
Assembly
Figure 1
1.
Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care not
to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
