Fanelite FANDC52, Руководство пользователя

Страница: 29 / 32

27
15. CLEANING AND MAINTENANCE
WARNING : Before cleaning your appliance, carefully read the safety instructions in this manual.
We recommend that you keep your unit clean and clean it at least once a month.
Do not use water or detergent to clean your ceiling fan.
A dry, soft cloth will be preferable to avoid scratching the body of your ceiling fan and the blades. Vacuum
dust from inaccessible places.
It is recommended to regularly check the condition of the ceiling fan and ceiling fan hanger bracket (at least
twice a year depending on use). Due to frequent use of the ceiling fan, the screws will tend to loosen a little
bit over time. Check and tighten the screws of the ceiling bracket, blades, motor cover, bottom cover if nec -
essary.
16. TROUBLESHOOTING
NOTE : Visit our Frequently Asked Questions section on our website (www.fanelite.com) for more
information.
The ceiling fan (motor) starts and then stops after few seconds :
This is a safety mode of the receiver because the blades are not installed. Install the blades before using your
ceiling fan.
The ceiling fan no longer works :
1. Check the batteries status of your remote control. Change the batteries if necessary and your ceiling fan
will re-operate normally.
2. If, despite the changed batteries, your ceiling fan still does not work, check the condition of the circuit
breakers. If the ceiling fan circuit breaker is OFF, put it back to ON. If the circuit breaker trips OFF again, do
2/ Wait a few seconds then turn on the power again.
3/ Within 20 seconds of turning on the power, press and hold the button of the remote control for around
3 seconds.
The receiver beeps when the synchronization is complete. You will then be able to use your remote control
to control your ceiling fan.
4/ PAIR THE REMOTE CONTROL ON SEVERAL CEILING FANS
When several FANDC52 ceiling fans are installed, it’s possible to control all of them with only one single
remote control.
Repeat the above procedure PAIRING PROCEDURE REMOTE CONTROL / RECEIVER with all the other
ceiling fans that you want to synchronize on the same remote control.
5/ INSTALL THE WALL SUPPORT OF THE REMOTE CONTROL
Install the supplied wall support by using screws and washers adapted to the structure of your wall so that
you can store your remote control on its wall support.