Fancom AURA 37, Руководство пользователя

Страница: 13 / 36

Aura 37 User settings
10

1,2,3...10 Readout of the bending points of the curve (maximum 10).
Setting of the day on which the new curve values must apply.
Setting of the curve value (ºC/ºF) for the start temperature ventilation (setpoint
house).
Setting of the curve value (%) for relative humidity.
Setting of the curve value (%) for minimum ventilation.
Setting of the curve value (%) for maximum ventilation.
The day number is a counter increased by the controller each day at midnight by one up to a maximum
of 999. If the day number is 0 it will not change. The Aura 37 then controls without the curve, even if the
bending points have been set.
If a curve is used, the day number is the basis used to calculate the setpoints from the relevant curve. If
a negative day number is set, the Aura 37 will control without using the curve, until the day number is a
positive number. A negative day number is also increased at midnight by one, except the jump from day
–1 to day +1 (a jump of 2).