Fancom AURA 37, Руководство пользователя

Страница: 29 / 36

Aura 37 Installer settings
26
Heating / cooling
Temperature hysteresis Setting of the temperature by which the control computer automatically activates the
heating / cooling. This prevents the cooling being activated / deactivated with slight
temperature fluctuations.
Link setpoint house Setting to link the heating / cooling to the setpoint house. This is normally used for the
standard heating / cooling control.

YES : The control value heating / cooling automatically follows the house
temperature, even if this is linked to the curve.

NO : The control value heating / cooling is not linked to the setpoint house and
have their own setpoint.
Exhaust fan
Correction factor
Setting of the amount of adjustment. A small value will lead to a small adjustment to
the output.
Correction buffer (%) Setting of the correction buffer % (by using other control types).
Correction buffer: Each control time the computer registers the difference
between the measured and control value and adds this to any previous
differences. As soon as the total sum exceeds the value of the correction
buffer, the computer will correct the output.
Sidewall-inlet / tunnel-
inlet
Pre run time (sec)
Setting of the time in which the air inlets go to the required position, before the fans
activate.
Humidification
RH hysteresis (%) Setting of the hysteresis value which prevents the activation or deactivation of the
control caused by small fluctuations.
Combi
Output 1-8
Readout of the output relais numbers.
Maximum repeat time
(mm:ss) Setting of the maximum repeat time (the repeat time can never exceed this value).
Optimal ON/OFF time
(mm:ss) Setting of the optimal repeat time for modulation.
Remaining time Readout of the on and the off time.