33
TROUBLESHOOTING
9
The ClubSport Wheel Base V2 must not be modified differently than described
in this manual. Endor® AG expressly prohibits analysis and utilization of the
electronics, hardware, software and firmware contained in the controller. In
case difficulties occur in connection with utilization of the ClubSport Wheel Base
V2, please use the following guide for elimination of errors. On the website
www.fanatec.com/support you will find further details and contact data.
If the ClubSport Wheel Base V2 is not working properly:
Problem description
Solution
After firmware update of the ClubSport Wheel
Base V2 the steering wheel is not properly
centered.
After doing a firmware update on the ClubSport
Wheel Base V2 the wheel center position must
be manually calibrated. See chapter ‘ClubSport
Wheel Base V2 Functions’ ‘Firmware and
driver update’ of this manual for more details.
After firmware update of the ClubSport Wheel
Base V2 the H-pattern shifter is not working
properly.
After doing a firmware update on the ClubSport
Wheel Base V2 the H-pattern shifter must be
manually calibrated. See chapter ‘ClubSport
Wheel Base V2 Functions’ ‘Firmware and
driver update’ of this manual for more details.
The driver window does not show the attached
Steering Wheel.
Make sure that you have updated your ClubSport
Wheel Base V2 to the latest firmware version
which can be downloaded from
www.fanatec.com/ support.
Check the pins inside the quick release of the
Steering Wheel, these must not be bent or
damaged.
Try to use another Steering Wheel. If this is also
not detected the ClubSport Wheel Base V2 might
be damaged.
Clean only with a dry or slightly damp cloth. Using cleaning solutions may dam-
age your ClubSport Wheel Base V2.
CLEANING
8
