7.
Install the slide assemblies, with brackets into the rack enclosure.
The return flanges on the mounting brackets and outer parts fit to the inside of the
rack-mounting rails.
8.
Verify the slide assemblies are in the same alignment position on all four rack-mounting
rails. After checking alignment, TIGHTEN ALL SCREWS.
9.
Insert the UPS, with inner parts attached, into the slide assemblies. You may need to
depress the locking mechanisms on the inner and outer parts of the slide assemblies
to allow the slides to retract. The UPS should move smoothly forward and backward on
the slide assemblies. If not, recheck alignment.
10.
Once the UPS is installed in the rack, the load may be connected to the output of the
UPS. Ensure the equipment being connected is turned off. Plug all loads into the
output receptacles on the rear of the UPS. Plug the UPS into a dedicated wall
receptacle that is protected by a circuit breaker or fuse in accordance with national and
local electrical codes.
Use a 15 amp rated device for 1500 VA units, 20 amp for the 2200VA, and
30 amp for 3000VA. The wall receptacle must be grounded.
11.
To turn on the UPS, switch on the input circuit breaker; wait for the UPS to switch from
bypass to inverter mode and then turn on the connected equipment.
Free-standing (tower) Installation (mounting feet to be purchased seperately)
When installing the SSG Series UPS in a free-standing configuration, mounting feet for the
SSG1.5KRM-1 model may be purchased seperately to stableize the UPS
provided with mounting feet (shown below, left) to stabilize the UPS. The SSG2.2KRM-1 and
SSG3KRM-1 models are provided with keyhole hardware to "lock" the UPS and battery bank units
together. This key lock is also required if additional battery packs are added.
X
Mounting feet
Mounting feet for additional
battery banks
SSG1.5KRM-X Free Standing
SSG2.2KRM-X & SSG3KRM-X Free Standing
12
