WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
34
ArtNo.320-0005 Oven door rubber seal
ArtNo.270-0033 - 90 Prof+ FX - Removing the oven inner door panel
5 Doors
5.1 Removing the Oven Door
To remove the oven door, open the door fully. Swivel the
locking ‘U’ clips forward to the locking position
(Fig.9-11)
.
Grip the sides of the door, lift upwards and then slide the door
forwards.
5.2 To Replace a Door Inner Glass Panel
Remove the oven door (see 5.1)
Carefully place the door, outer side up, on a clean level surface.
Remove the 2 hexagon headed screws from the inside face
and the 3 hexagon headed screws on the bottom edge
(Fig.9-12)
.
Remove the corner brackets, and then lift off the inner door
panel. Take care not to damage the inner glass.
Reassemble in reverse order.
5.3 To Replace an Over Door Hinge
Remove the door and door inner panel (see 5.1 & 5.2).
Undo the screws securing the hinge in place. Remove the
hinge. Replace the hinge and rebuild the door in reverse order.
5.4 To Remove the Oven Door Seal
Open the oven door. The seal is held in place by small hooks to
the cooker front. At the corner, pull the seal diagonally away
from the door centre until that hook is released
(Fig.9-13)
.
Proceed to the next hook and release it in a similar way, and
so on. Use force if the hooks are stiff, as the old seal will be
discarded.
When fitting the new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door, and
proceed round the door snapping in each hook in turn.
6 Ancillaries
6.1 To Change the Cooling Fan
Remove the hotplate (see 2.1).
Remove the screws that hold the cooling fan to the duct
(Fig.9-14)
, and then lift out the fan.
Reassemble in reverse order.
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig. 9.11
Fig. 9.12
Fig. 9.13
Fig. 9.14
