INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
24
Fitting the Stability Bracket and Chain
n
n
A stability bracket and chain MUST be fitted when
the cooker is connected to a flexible gas supply.
Unless properly installed, the cooker could be tipped by
leaning on the door. Injury might result from spilled hot
liquids or from the cooker itself.
IMPORTANT:
The cooker must be set to the correct height
and levelled before the stability bracket is installed.
Fitting a Stability Bracket
When fitting a stability bracket please refer to the instructions
supplied with the bracket for further details on fitting.
When fitting a stability bracket (
Fig.7-7
and
Fig.7-8
) adjust
the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Fitting the Restraining Chain
The restraining chain MUST be fitted.
The length of chain between the appliance and the wall fixing
should prevent strain on the gas and electricity connections,
but still allow access to unhook the chain when the cooker is
pull forward.
Measure the length of chain required. Use the hexagon-
headed screw, washers and bolt supplied in the restraining
chain kit to fix the chain to one of the holes at the top of the
flue trim bracket
(Fig.7-9)
.
Hook the other end of the chain to the wall fixing.
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
3 mm min
Typical floor mounting
Cooker
Outer stability
bracket
Floor
Wall
3 mm min
Typical wall mounting
ArtNo.070-0001 - Fitting the restaining chain
Fig. 7.7
Fig. 7.8
Fig. 7.9
