Falcon Professional+FX, Руководство пользователя и инструкции по установке

Страница: 34 / 44

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
30
ArtNo.272-0010 - 90 Prof+ pyro - Removing the splitter
OFF OFF
ArtNo.090-0021 Hotplate removal
9. Servicing
n n
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS. TURN OFF THE GAS SUPPLY
n n
DO NOT modify this appliance!
n n
Check the appliance is gas sound after completion
of service. When checking for gas leaks DO NOT use
washing up liquid – this can corrode. Use a product
specifically manufactured for leak detection.
n n
DO NOT use reconditioned or unauthorised gas
controls.
n n
Disconnect from the electricity supply before
servicing, particularly before removing any of the
following: control panel, side panels, hotplate tray
or any electrical components or covers.
n n
Before electrical reconnection, check that the
appliance is electrically safe.
1. Panels
1.1 To Remove the Control Panel
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control knobs. Open the oven door. Undo the
4 screws on the oven beak
(Fig.9-1)
. Remove the 3 fixing
screws on the underside of the control. The control panel
should drop down slightly. It is held at each end by 2 holes
in the top edge
(Fig.9-2)
that locate on the tags on the inner
panel.
Lift the control panel clear of the tags and pull the control
panel forward
(Fig.9-3) . Disconnect the wiring from the rear.
Lift the panel clear of the cooker.
Replace all parts in reverse order. When replacing any
electrical connections refer to the wiring diagram.
1.2 To Remove the Side Panels
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel. Undo the 3 screws securing the
plinth and remove.
Undo the lower retaining screw situated below the edge at the
panel front corner. Remove the side panel retaining screw on
the upper front edge and the 2 fixings on the rear or the side
panel. Remove the panel by pulling it away from the cooker.
2 Hotplate
2.1 To Remove the Hotplate
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove pan supports and burner heads. Remove the 10
screws holding the hotplate burners to the hotplate. Remove
the 6 screws holding the hotplate tray to the cooker
(Fig.9-4) .
Taking care not to damage the burner heads, lift the hotplate
clear of the cooker.
Reassemble in reverse order, making sure that the leads are
reconnected correctly.
Check the burner operation.
ArtNo.270-0032 - 90 Prof+ FX - Removing the control panel
ArtNo.270-0019 - Proplus tags 2
Fig. 9.1
Fig. 9.2
Fig. 9.3
Fig. 9.4