17
ArtNo.311-0014 Wok burner details
�
�
�
�
�
ArtNo.311-0016 Fitting the burner inner head
�
�
Fig.6-2
Fig.6-4
Hotplate Burners
The burner heads and caps can be removed for cleaning.
Make sure they are absolutely dry before replacing.
The Single Ring Burners
When refitting the burner head, ensure that the notch lines
up with the electrode or hole in the base. Check that the
burner head is level and that the cap is fitted centrally on the
burner head
(Fig.6-1)
.
The Wok Burner
When reassembling the wok burner
(Fig.6-2)
turn over the
large base ring and find the ‘D’ shaped area
(Fig.6-3)
. Turn the
head until the ‘D’ matches the one on the burner base. Flip
the burner over once again and place it on the burner base.
To fit the small inner burner, find the larger electrode notch
in the burner rim. Line this up with the ignition electrode and
place the inner burner on the large base ring
(Fig.6-4)
.
Now fit the two burner caps, ensuring that they are seated
properly.
Check the burner ports are not blocked. If a blockage occurs,
remove stubborn particles using a piece of fuse wire.
Griddle
Always clean the griddle after use. Allow it to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.
The Wok Cradle
Recommended cleaning materials are hot soapy water, a
moistened soap pad, cream cleaner or nylon scourer.
Control Panel and Oven Doors
Avoid using any abrasive cleaners including cream cleaners,
on brushed stainless steel surfaces. For best results use liquid
detergents.
The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
A - Inner burner cap, B - Outer burner cap, C - Inner burner head,
D - Outer burner head, E - Wok burner base
ArtNo.311-0015 Burner alignment
���
Fig.6-3
A - Electrode notch, B - Ignition electrode
