Falcon Professional+100 FX Dual Fuel, Руководство пользователя и инструкции по установке

Страница: 40 / 44

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
36
Top strip
Rubber strip
ArtNo.320-0005 Oven door rubber seal
5 Doors
5.1 To Replace an Oven Door
Open the oven door fully and place the supplied
holding pins in the drop down hinges (Fig. 9.10) .
Lift the door panel up and out.
Carefully fit the new door panel and push down gently
to release the holding pins.
n n
THE DOORS ARE HEAVY, SO TAKE CARE.
5.2 Oven Door Glass
The inner glass on both oven doors is replaceable.
Open the oven door fully and place the supplied
holding pins in the drop down hinges
(Fig. 9.10)
.
Lift the door panel up and out.
Remove the top 2 fixing screws using the Allen key
supplied and the door top strip (Fig. 9.11) . Then lift the
2 glass panels out.
To refit the door glass correctly, make sure that the
printed circle and square on the glass, match up to the
pressed holes of the same shape. This will ensure the
heat reflective side is in the correct position, facing
towards the oven.
Make sure that the rubber strips are all attached.
Carefully refit the door panel and push down gently to
release the holding pins.
n n
ENSURE THAT ALL PIECES OF BROKEN GLASS ARE
REMOVED
5.3 To Replace an Oven Door Outer Panel
Open the oven door fully and place the supplied
holding pins in the drop down hinges
(Fig. 9.10)
.
Lift the door panel up and out.
Remove the top 2 fixing screws using the Allen key
supplied and the door top strip (Fig. 9.11) . Then lift the
2 glass panels out.
Remove the two nuts located on the inside of the door
panel, to release the handle (Fig. 9.12) .
Remove the two fixing screws located at the base of the
oven door and remove the outer door panel
(Fig. 9.12)
.
Reassemble in reverse order.
5.4 To Change an Oven Door Seal
Open the oven door. The seal is held in place by small
hooks on the rear face. At the corner, pull the seal
diagonally away from the door centre until that hook
is released
(Fig. 9.13)
. Proceed to the next hook and
release it in a similar way, and so on. Use force if the
hooks are stiff, as the old seal will be discarded.
When fitting the new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door, snapping in each
hook in turn.
Fig. 9.10
Fig. 9.11
Fig. 9.12
Fig. 9.13
Handle
fixings x 2
Outer
door panel
screws x 2