Falcon Professional+100 FX Dual Fuel, Руководство пользователя и инструкции по установке

Страница: 29 / 44

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
25
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
3 mm min
Typical floor mounting
ArtNo.010-0004 Moving the cooker
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig. 7.3) . Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise. Make sure you
lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the pack base tray.
We recommend that you remove the oven doors to move
the cooker. Open the oven door fully and place the supplied
holding pins in the drop down hinges
(Fig. 7.4)
.
Carefully lift the door panel up and out, place safely to one
side. You can now get a good grip from inside of the oven
(not the fascia panel) as you move the oven
(Fig. 7.5)
.
Carefully push the cooker backwards off the cardboard base.
Remove the pack base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
After moving, carefully refit the door panel. Push down gently
to release the holding pins and remove them.
n n
Do not use the door handles or control knobs to
manoeuvre the cooker.
Levelling the Cooker
It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position. Take care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the hexagonal adjusting
nuts at the front bottom corners of the cooker.
To set the front turn the feet bases to raise or lower.
Fitting the Stability Bracket and Chain
n n
A stability bracket and chain MUST be fitted when
the cooker is connected to a flexible gas supply.
Unless properly installed, the cooker could be tipped by
leaning on the door. Injury might result from spilled hot
liquids or from the cooker itself.
IMPORTANT: The cooker must be set to the correct height
and levelled before the stability bracket is installed.
Fitting a Stability Bracket
When fitting a stability bracket please refer to the instructions
supplied with the bracket for further details on fitting.
When fitting a stability bracket (
Fig. 7.6 and Fig. 7.7 ) adjust
the bracket to give the smallest practicable clearance
Fig. 7.3
Fig. 7.4
Fig. 7.5
Fig. 7.6
Fig. 7.7
Cooker
Outer stability
bracket
Floor
Wall
3 mm min
Typical wall mounting