TIDYING AWAY YOUR CABLES
Once your camera is installed and the cable has been run into your van you can
now use a piece of cable trunking to hide away any exposed cables on your roof
if your hole into the van is located away from your camera. Apply adhesive to the
base of the trunking and place in the most direct path from the camera to the
cable entry gland, apply a gentle amount of pressure to the trunking to spread
the adhesive evenly and leave for 1 hour
After 1 hour the trunking should be firmly attached to your roof, remove the
trunking lid and run your cable through the trunking, then seal the lid of the
trunking back on leaving a nice water tight and tidy finish to the roof of your van.
We also recommend sealing the opening and closing end of the trunking with
the adhesive to seal it from water or wind.
Remove any excess adhesive with isopropyl rubbing alcohol or similar.
CONNECTING THE POWER SUPPLY TO THE CAMERA
In the van, evaluate your route to your power outlet.
Assess the position where you want your power button, mark and drill a 20mm
hole.
Feed the cable through the hole and cut to the required length, strip the cable at
the 2 cut ends so you have 2 x red positive cables and 2 x negative cables.
