ASSEMBLING THE CAMERA
Place the camera mount onto the camera base and insert the self-tapping screw
through the white screw caps and screw the mount to the base in the pre-drilled
holes, then close the cap. Repeat for both holes.
Place the camera into the camera mount, align the camera with the 2 holes on
both sides of the bracket and use the 4 screws to set the angle of your camera.
Screw the antenna onto the back of the camera
Now the camera is set up and ready for installation.
INSTALLING THE CAMERA
Find a location where the camera base can rest fl at on the back of your vehicle
and clean the area to make sure it is free of any dust or debris. Place the base and
mark around the base with a insulation tape. Apply the glue to the bottom of
the camera base and place the camera base in the marked area. Scrape away any
excess glue. Leave on for 1 hour.
After an hour, remove the tape from around the camera base and remove any
remaining excess adhesive with isopropyl rubbing alcohol or similar.
