10
Communication error
Re-set required
Failure on LIN or CAN-Bus
Switch unit off for 10 seconds, then on
Engineer required
11
Initialisation error
Re-set required
Software failed when initialising
hardware
Switch unit off for 10 seconds, then on
Wait. Generator will re-set every 30 seconds
Engineer required
12
Current reading failure
Re-set required
Generator detects that current does
not reflect what controls require
Switch unit off for 10 seconds, then on
Engineer required
13
Mains connection
error
Re-set required
Mains voltage is too high or too low
Switch unit off for 10 seconds, then on
Engineer required
14
Mains connection
error
Re-set required
Mains voltage is too high or too low
Switch unit off for 10 seconds, then on
Engineer required
15
Coil electrical circuit
self protected
Re-set required
Refer to fault 04
Switch unit off for 10 seconds, then on
Refer to fault 04
Code
Error
Cause
Action by user
