Operating Modes
Note:
The turntable belt
MUST
be on the
SMALL
pulley for proper operation.
Standby Mode:
The PSU will power up in
Standby Mode
as indicated by 3 dashes:
Sleep Mode:
While in
Standby Mode
, if no activity is detected for 5 min., the PSU will revert to
Sleep Mode
and blank the display.
Normal Mode:
To Exit
Sleep
or
Standby Mode
, press and release the
Stby
button. The PSU will
revert to the last used speed and output the appropriate AC signal to the motor. The display will
show the currently selected speed or offset:
Soft Start:
Whenever the Falcon PSU exits
Standby Mode
, it starts the platter at ~20RPM and
evenly ramps up the speed to prevent “burn out” on the belt. This greatly extends the belt life and
improves long term speed stability.
To change between 33.3 and 45.0 RPM, press and release the
Stby
button.
To adjust the turntable speed in 0.1 RPM increments, press and release the
Plus
or
Minus
buttons.
To stop the turntable platter and return to
Standby Mode
, press and hold the
Stby
button until the
3 dashes are displayed.
