Falcon 50 FM, Руководство по эксплуатации, Страница: 29 / 30

TECHNICAL SPECIFICATIONS
ENG
Page 29
10 TECHNICAL SPECIFICATIONS
GENERAL
Dimensions 3 rack unit, 352 x 483 x 132 mm ~ AC Rate 230 Vac 50 Hz / 110 Vac 60 Hz +/-10%
Weight Around 7 Kg Power consumption 25 VA
ANALOG AUDIO INPUT DIGITAL AUDIO INPUT
Conversion 24 bit Sigma-Delta (Crystal CS4272) Connector Type XLR female & optical tos/link
Connector Type XLR female el. Balanced - EMI –suppressed Formats AES3/EBU
Nominal Level adj - 10.0dBu to +15.0dBu (0.1dBu step) Input Rates
32/44.1/48/64/88.2/96KHz with automatic
selection and jitter correction
AD Clipping Point 0.0dBu to 24.0dBu (0.1dBu Step) Nominal Level adj From 0.0dBFs to –25dBFs (0.1dBu Step)
AD Dynam. Range 104 dB RMS (107dB A weighted) Dynamic Range 125dB (Typ), 122dB (Min)
Impedance 600Ohm / 10KOhm Resolution
16 / 20 / 24 bit
Input Modes
Stereo, Mono L+R, Mono L, Mono R, L/R
Swapped, separated R & L polarity inversion
Input Modes
Stereo, Mono L+R, Mono L, Mono R, L/R
Swapped, separated R & L polarity inversion
Phase Rotator & Hi
Pass Filter Selectable & Configurable separately from
Digital Input Phase Rotator & Hi
Pass Filter Selectable & Configurable separately from
Analog Input
ANALOG AUDIO OUTPUT DIGITAL AUDIO OUTPUT
Conversion 24 bit Sigma-Delta (Crystal CS4272) Connector Type XLR male & optical tos/link
Connector Type XLR male el. Balanced - EMI –suppressed Formats AES3/EBU, IEC60958, EIAJCP1201
Nominal Level -5.0 dBu to +20.0dBu (0.1dBu step) Sample Rates
32/44.1/48/64/88.2/96KHz internal or
synchronized to Digital Input / AES-EBU
SYNC Input
Source Impedance 50 Ohm Output Level From 0.0 dBFs To –25.0dBFs (0.1dBFs Step)
Load impedance 600 Ohm or greater Resolution 16 / 20 / 24 bit
Group Delay 5 msec Group Delay 5msec
INPUT SELECTION
(either the Analog or the Digital Input can be set as primary)
Switch Mode - Switch from a software command Fail mode
-
No Signal on Primary input
- Switch from a remote command - Signal under - 30dB of nominal value
- Switch in the event of audio failure - Left-Right unbal > 6dB on Primary channel
Fail Time
5-60Sec (step 5 Sec)
Restore Time
1-10 Sec (step 1 Sec)
AUX IN (1,2 and 3) SYNC-OUT
Connector Type floating BNC, EMI suppressed Connector Type floating BNC, EMI suppressed
Level –20dB or 0dB Gain (jumper selectable). Sync-Out TTL-level (5Vpp) 19 kHz Pilot Ref. Out
Input Impedance > 10 Kohm
REMOTE CONTROL (GPI) INTERFACE REMOTE COMPUTER INTERFACES
Inputs 6 TTL level Serial Ports 1 x RS-232 38400 Baud
Outputs 4 TTL level Ethernet interface Static IP 10/100Mbits Interface (option)
Connector SubD 25 pin USB interface 2 Port Usb 2.0 Full Speed
Type optically decoupled
Rem. Ctrl software
Dedicated, for Win 95,98,XP,NT,2000