C- Pressure Hose
D-
Insert the pressure hose in to the
corresponding aperture of the adapter
supplied and secure to the suction hose
or suction tube at regular intervals. Insert
the quick release coupling at the end of
the hose into the mating socket in to the
hood and push it home so that it locks.
The pressure hose connection can be
straightforwardly released. To do this
push the corrugated sleeve of the quick
release coupling back so that the coupling
is automatically forced out under spring pressure.
E- Spray Extraction Liquid Tank
Connection Hose
-
Push the plug
connector on the connection hose in to
the corresponding aperture in the hood
as far as it will go. Take care to ensure
that the hose is not kinked and that the
end of the hose with the strainer is positioned at the
bottom of the tank. Spray extraction liquid.
Remove the screw plug from the tank and pour in the
mixture of water and concentrated cleaning agent with
the aid of the funnel. The capacity of the tank is 4.5 liters.
CAUTION!!! Use only non-polluting, environment-
friendly cleaning agents. Please observe the mixture
ratio specified by the manufacturer.
F- Accessories
- Insert the floor nozzle
(or the sofa nozzle) on the extension
tubes. Connect the sprayer tube to the
pin of the extension tubes (push and turn
anti-clockwise).
E- Float Valve
- When the maximum liquid
level in the canister is reached, the float
valve will automatically close the intake
aperture in the hood, interrupting the
intake process. Switch off the appliance
immediately and withdraw the mains plug.
Carry or pull the complete appliance to the disposal point
and empty the canister.
F- Water Discharge
- To empty the liquid
from the tank, turn off the motor switch
and open the water discharge. Before
switching it on again verify the water
discharge is closed.
ATTENTION!!! When the machine is working never
open the water discharge (F).
Note: If foam or liquid escapes from the ventilation
apertures during cleaning operations, switch the
appliance off immediately and withdraw the mains
plug. Empty the canister and if necessary add some
anti-foaming agent. Carry out a function check on
the float valve before switching on the appliance
again.
Preparation for Spray Extraction
Before extraction cleaning of carpeted floors or upholstery
check the color-fastness of the material. To do this apply
some of the concentrated cleaning agent to an in
conspicuous area with a cloth allow it to dry, then carry
out a color comparison. The floor covering or upholstery
should only be cleaned if no change of color is evident.
A- Tank
- Release the canister clamps,
remove the hood, cartridge filter and
paper filter if fitted. To remove the filter
turn the filter retaining clip anti-clockwise
and pull off the filter cartridge including
the base plate.
B- Foam Plastic Filter
-
Install the foam
plastic filter by pushing the filter completely
onto the float valve retainer as far as it
will go. Now reinstall the hood on the
canister, fasten the canister clamps and
install the extraction cleaning accessories.
Spray Extraction of Carpeted Floors
A-
After desired accessory has been
selected and installed, proceed as follows:
• Unwind the mains lead and insert the
plug into the power point.
• Set the control switch to maximum
suction power.
• Switch on the appliance by lightly
pressing the ON/OFF switch.
• Start the pump by the applying light
pressure to the switch.
B- Method of Operation
03
