Fagor QF-1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 28

www.Fagorcommercial.com
PAGE 8
REACH-INS OPERATIONAL SERVICE MANUAL / Rev.JUN. 2015
Slide out unit until castor holes are exposed. CASTORS WITH BRAKES MUST BE INSTALLED IN THE
FRONT OF THE UNIT
Carefully, lift the unit high enough to install the casters.
Repeat the same operation to install the remaining castors.
CAUTION!
NEVER LAY MACHINE ON ITS BACK! IF NEEDED, LEAVE THE CABINET UP RIGHT FOR 24
HOURS BEFORE CONNECTING TO POWER SOURCE. TO AVOID DAMAGE TO LOWER FRAME, SLOWLY
RAISE UNIT TO UP RIGHT POSITION
FAILURE TO MEET THIS REQUIREMENT CAN CAUSE COMPRESSOR FAILURE AND UNIT DAMAGE. THIS
WILL NOT BE COVERED UNDER WARRANTY!
For leveling, insert shims between the castor and the frame rail. Install the desired number of shims.
Make sure the slot of the shim is in contact with the threaded stem of the castor.FIG.2
If more than one shim is used, turn the slot of the shim approximately 90 angles. If shims are installed
in line, they may slip out.
Turn the bearing race clockwise to tighten and secure the castor. Use provided tool to secure all
castors properly.FIG.3
FIG.1 FIG.2 FIG.3
Optional legs are hand-tightened. Thread leg into cabinet bottom frame rail. The end of the leg is
adjustable for easy leveling.
Caution! To avoid damage to lower rail assembly, slowly raise unit to upright position
Caution! When lifting unit remember to leave the cabinet up right for 24 hours before plugging into
power source. Failure to meet this requirement can cause compressor failure and unit damage.