Fagor FDD24, Руководство по обслуживанию

Страница: 18 / 29

BAR EQUIPAMENT OPERATIOS AND SERVICE MANUAL
Gaskets can easily be replaced and do not require the use of tools or
authorized service persons. The gaskets can be pulled out of the grove
in the door and new gaskets can be “pressed” back into place.
Door Hinges
Over time and with heavy use door hinges may become loose. If it is
noticed that the door is beginning to sag, it may become necessary to
tighten the screws that mount the hinge brackets to the frame of the
unit. If the doors are loose or sagging this can cause the hinge to pull
out of the frame which may damage both the doors and the door
hinges. In some cases this can require qualified service agents or
maintenance personnel.
Drain Maintenance
Each unit has a drain located inside the unit which removes the
condensation from the evaporator coil and evaporates it at an external
condensate evaporator pan. Each drain can become loose or
disconnected from moving or bumping the drain. IF YOU NOTICE
EXCESSIVE WATER ACCUMULATION ON THE INSIDE OF THE
UNIT be sure the drain tube is connected from the evaporator housing
to the condensate evaporator drain pan.
IF WATER IS COLLECTED UNDERNEATH THE UNIT you may want
to check the condensate evaporator drain tube to be sure it is still
located inside the drain pan. The leveling of the unit is important as the
units are designed to drain properly when on a level surface, if your
floor is not level this can also cause drain problems. Be sure all drain
lines are free of obstructions, typically food product is found blocking
drain lines causing water to back up and overflow the drain pans.