Fagor FDD24, Руководство по обслуживанию

Страница: 17 / 29

BAR EQUIPAMENT OPERATIOS AND SERVICE MANUAL
6 MAINTENANCE
Stainless Steel Care and Cleaning
Proper cleaning of stainless steel requires soft cloths, never use steel
pads,wire brushes or scrapers!
Cleaning solutions need to be alkaline or non-chloride cleaners. Any
cleaner containing chlorides will damage the protective film of the
stainless steel. Chlorides are also commonly found in hard water, salts,
household and industrial cleaners. If cleaner containing chlorides is
used be sure to rinse repeatedly and dry thoroughly upon completion.
Routine cleaning of stainless steel can be done with soap and water.
Extreme stains or grease should be cleaned with a non-abrasive
cleaner and plastic scrub pad. There are also stainless steel cleaners
available which can restore and preserve the finish of the steel's
protective layer.
Never use an acid based cleaning solution! Many food products have
an acidic content which can deteriorate the finish. Be sure to clean ALL
food products from any stainless steel's surface. Common items include
peppers, tomatoes and other vegetables.
Cleaning the Condenser Coil
DANGER: Power must be turned off and
disconnected from the power source whenever
performing maintenance, repair or cleaning the
condensing unit.
Disconnect unit from power supply. Remove front bottom panel and
carefully slide out the condensing unit.The condenser coil requires
regular cleaning; recommended is every 30-60 days, depending the
accumulation of dust and grease.
If the build up on the coil consists of only light dust and debris the condenser
coil can be cleaned with a simple brush. Heavier dust build up may require a
vacuum or even compressed air to blow though the condenser coil.
If heavy grease is present there are de-greasing agents available for
refrigeration use and specifically for the condenser coils. The condenser coil
may require a spray with the de-greasing agent and then blown through with
compressed air.
Be sure all electrical and mechanical parts are dry before
turning on the power.
Never use a high pressure water wash for this cleaning procedure as water
can damage the electrical components located near or at the condenser coil!
Do not place filter material in front of condenser coil. This material blocks air-
flow to the coil similar to having a dirty coil!
If you keep the condenser clean you will minimize your service expense and
lower your electrical costs. Failure to maintain a clean condenser coil can
initially cause high temperatures and excessive run times. Continuous
operation with dirty or clogged condenser coils can result in compressor
failures.
Neglecting the condenser coil cleaning procedures WILL VOID YOUR
WARRANTY associated with the compressor or cost to replace the
compressor!
To put back the condensing unit in its place, slide in the unit carefully. BE
SURE DRAIN PIPE IS LOCATED OVER THE PAN. Replace front bottom
panel.
Gasket Maintenance
Gaskets require regular cleaning to prevent mold and mildew build up and
also to keep the elasticity of the gasket. Gasket cleaning can be done with the
use of warm soapy water. Avoid full strength cleaning products on gaskets as
this can cause them to become brittle and prevent proper seals. Also, never
use sharp tools or knives to scrape or clean the gasket which could possibly
tear the gasket and rip the bellows.