Fagor CNC 8060, Перевод оригинального руководства

Страница: 130 / 180

Remote modules.
CNC 8060
CNC 8065
7.
RCS-S-4F4
AO (SERCOS-II
PROTOCOL).
Se
cu
ring the modu
le.
·130·
(R
EF
: 1906)
7.4 Securing the module.
7.4.1 Ambient characteristics.
The RCS-S modules must be installed inside an electrical cabinet with a protection rating
of IP54 or higher. The ventilation for the electrical cabinet must be enough to dissipate the
heat generated by all the devices and components working inside. The interior temperature
of the cabinet must not exceed 55ºC (113ºF) while the unit is running.
7.4.2 Securing the module.
When attaching the modules, the following requirements must be met.
• Place the modules in a vertical position.
• Place the modules on 2 profiles, in accordance with EN 50022 (DIN 46277-3) (TS 35),
66mm (2.60") apart. Attach the modules using two fastening caps (one on each side of
the module) to maintain a proper clearance between the profiles and lock the modules
in place.
• Always leave a 140 mm (5.51") gap under the modules for ventilation and later handling.
DIN 46277-3
DIN 46277-3
a b
c
mm inch
a 43 1.69
b > 25 (*) > 0.98 (*)
c 66 2.60
d 140 5.51
(*) There must be enough “b” distance
between modules to respect the minimum
bend radius if the fiber optic cable.
d
b
EN 50022
EN 50022
R
Cable. R (minimum bend radius)
SFO Minimum bending radius of 30 mm.
SFO-FLEX Minimum static bending radius of 50
mm and a dynamic radius of 70 mm.
SFO-V-FLEX Minimum static bending radius of 45
mm and a dynamic radius of 60 mm.