Fagor AD-125, Инструкции по установке, использованию и обслуживанию

Страница: 74 / 148

EN
74
When the wash cycle ends, open the hood and remove the basket, allowing the dishes to dry by evaporation
for a minute.
•
Remove the basket from the appliance and handle the dishes/cutlery with gloves or clean hands to
prevent contamination. Be careful as the dishes will be hot.
•
Do not dry the dishes with kitchen towels or cloths that are not sterile.
•
Operators must strictly observe all hygiene requirements when handling clean dishes and cutlery.
To stop the wash cycle before it has finished:
•
Models with START button: press START.
•
Models with cycle selector switch, SELECT: Turn the SELECT switch to another position.
•
Models with ON/OFF button: Press the ON/OFF button and switch off the machine.
Models with ON/OFF button: Press the ON/OFF button and switch off the machine. The cycle
EXT.WASH P3 stops when P3 is held down for more than 3s with the hood closed.
Selecting the wash cycle :
C1 - Short
C2 -
Medium
C3 - Long EXT.WASH
CO-110 90s 120s 180s 10min
P1 - Short
P2 -
Medium
P3 - Long EXT.WASH PG - Glass
CO-142 55s 75s 120s 10min -
COP-144 55s 75s 120s 10min -
AD-125 55s 75s 120s 8min 90s
Tank temp.
55 - 65 ºC / 131 - 149 ⁰ F
Boiler temp.
80 - 85 ºC / 176 - 185 ⁰ F -
65 ºC / 149 ºF
The cycle should be selected according to the dirt on the dishes:
Short cycle (for dishes which are not very dirty)
Medium/standard cycle (for fairly dirty dishes)
Long cycle (for very dirty dishes or dishes with dried-on dirt)
PG (Glass Programme): Glass wash cycle with rinse temperature of 65 ºC / 149 ºF.
In the
“C”
model, the technical service may modify the following parameters in any of the cycles at the
request of the user and under their responsibility:
Wash temperatures

[55-71 ºC] / [131-159 ºF]
Rinse temperatures

[65-85 ºC] / [149-185 ºF]
Cycle times

Wash: P1: 39s

[35s-60s] / P2: 59s

[55s-80s] / P3: 104s

[100s-500s] / PG:
74s

[70s-95s]
Rinse: 11s [10s-14s]
5.10.1
MOD “C”: Energy saving function:
The
“C”
model has a energy saving function which operates as follows:
Stand-by mode: When the machine is on stand-by, the boiler maintenance temperature is 5 ºC lower
than the setting temperature.
Saving mode: If the machine does not run a programme in an interval of 30 minutes, the dishwasher
switches to “Saving mode”. In this mode, the boiler maintenance temperature is 10 ºC
lower and the tank temperature 5 ºC lower than the setting temperatures.
5.11 Drainage and switching off the machine
At the end of the working day or when it is necessary to change the wash water because it is too dirty, the
wash tank should be drained.
IMPORTANT: WAIT AT LEAST 10 MINUTES AFTER SWITCHING OFF THE MACHINE BEFORE
CLEANING THE INSIDE OF THE APPLIANCE.
For correct drainage with the drainage pump, the height of the drain must not
be more than 800 mm above the level of the machine drainage.