EN
66
Adjusting the dose:
To ensure that the wash is optimised from the start, the dispenser should be adjusted
when the machine is installed. The setting should be adjusted according to the type of rinse aid and the
water hardness. Turn the adjustment screw until the required dose is obtained (turn clockwise to increase
and anticlockwise to reduce the dose).
Position
1
1,5
2
2,5
3
3,5
4
4,5
5
Dose (l/h)
0,14 0,21 0,28 0,35 0,42 0,49 0,56 0,63 0,7
Dose during
rinse cycle
(ml, cc)
0,4
0,6
0,8
1
1,2
1,4
1,6
1,8
2
In ECO models with hot water gas generator, the rinse aid dispenser connection should be on the hot water
generator itself.
4.7.3
Detergent dispenser (MOD “C”, Optional MOD “A” and MOD “B”)
ONLY use liquid detergents which are not foam-forming at high temperatures and which are of
commercial quality
. Please contact a qualified chemical product supplier.
Installation:
If the detergent dispenser is not pre-installed in the appliance, an installation kit can be ordered
from your supplier or manufacturer.
The tub has an opening for the installation of a detergent intake bushing in the appliance. This is marked
with the label “DETERGENT CONNECTION” and is located on the front of the wash tank, above the
maximum water level. The existing plug should be removed and the bushing inserted in the hole. The
detergent dispenser is installed in the lower front of the appliance and is connected electrically using the
existing connection and marking it to this effect.
After installing the detergent dispenser or if this has already been pre-installed at the factory, the end of the
clear tube with filter at the rear of the machine marked «Detergente / Detergent» should be inserted in the
detergent container.
The tubes are see-through to allow you to check that the chemicals are correctly dispensed.
To access the dispensers and adjust them, remove the lower front cover of the appliance.
Operation:
This dispenser absorbs and dispenses detergent when the rinse pump is switched on. That is,
when the machine is filling and during the rinse cycle.
Loading:
When the appliance is switched on, the loading process takes place automatically while the
machine is filling.
Adjusting the dose:
To ensure that the wash is optimised from the start, the dispenser should be adjusted
when the machine is installed. The setting should be adjusted according to the type of rinse aid and the
water hardness. Turn the adjustment screw until the required dose is obtained (turn clockwise to increase
and anticlockwise to reduce the dose).
Position
2
2,5
3
3,5
4
4,5
5
Dose
(l/h)
0,5 1,15
1,5
2
2,3 2,6
3
Dose during rinse cycle
(ml, cc)
1,5
3,5
4,5
6
7
8
9
Electrical
connection
(Rear section)
Tank wash
Regulation
Filter
Detergent
Содержание AD-125
Страница 14: ...14 MOD A CO 142 MOD B COP 144...
Страница 15: ...15 MOD C...
