Fagor 60CFP-36IX, Руководство по установке

Страница: 7 / 49

7
2/ INSTALLING YOUR APPLIANCE
INSTALLING MOUNTING PLATE
1. Place the template paper onto the ceiling. Drill holes as shown on the paper.
2. Put the drywall anchors into the holes, take out the mounting plate and use 12 pcs
mounting screws to secure the plate onto
the ceiling. For concrete ceilings, please use
the 8 pcs of the expanding screws).
3. Take out the 8 pcs of angle iron, use 8 pcs
of mounting screws(4*14mm) with washers
and nuts to fix 4 pcs of angle iron onto the
mounting plate
4. Adjust the height X of the chimney (as
shown on the picture 1), use 16 pcs of
mounting screws (4*14mm) with washers
and nuts to fix the other 4 pcs angle iron
onto the angle irons which have been
installed
.
INSTALLING THE DUCTWORK
NOTE: To reduce the risk of fire, use only metal ductwork.
1 Design the ductwork to vent between the hood and the outside.
2 A straight, short duct run will allow the hood to perform most
efficiently.
3 Let one side of the duct go outside through the hole of 6.7’’ (17 cm)
as shown.
EN