Fagor 101, Руководство по эксплуатации

Страница: 26 / 103

AUX MODE 5
Chapter: 2 Section: Page
2.2 MACHINE PARAMETERS
With this option, it is possible to analyze the machine parameters of the CNC and modify
their settings if the machine parameter memory is not locked.
These machine parameters are set by the manufacturer and are used to adapt the CNC to the
machine.
To access the machine parameters, press the keystroke sequence: [AUX MODE] [1]
The display information looks like this:
The top display shows the number of the machine
parameter.
The bottom display shows the current value of that
parameter.
To have another parameter display, use one of the following methods:
* Use the keys
* Press [CL] twice to clear the current display. Then, key in the desired parameter
number and press [RECALL]. The CNC will show that parameter.
Bear in mind that once the machine parameters have been set, either the [RESET] key
must be pressed or the CNC powered-down and back up in order for the new values
to be assumed by the CNC.
The installation manual describes all these machine parameters.
2.2.1 EDITING MACHINE PARAMETERS
The machine parameters must be edited one by one. Depending on the type of machine
parameter selected, it will take one of the following types of values:
A number P12 = 30000
A group of 8 bits P19 = 00001111
To edit a parameter which is assigned a number, proceed as follows once the desired
parameters has been selected:
* Press [CL]. The CNC clears the bottom display.
* Key in the desired value.
* Press [ENTER] to "enter" this value in the machine parameter table.
If the CNC does not assume this new value and it displays the previous one instead,
it means that the machine parameter table is locked.
MACHINE PARAMETERS