AUX MODE
6
Section:
Chapter: 2
Page
To edit a parameter defined with a group of 8 bits, once it has been selected, press
[CL] and enter the 8 bits or press [RECALL] and change the bits one by one.
To change the bits one by one, proceed as follows:
*
Press [RECALL]. The display will blink the first parameter bit.
*
To change this bit , press [0] or [1] accordingly.
*
Use the
keys to move from bit to bit (making them blink).
*
To change a particular bit, select it by making it blink and set it to the desired
value.
*
Once all the bits have been set, press [ENTER] for this value to be entered in the
machine parameter memory.
If the CNC does not assume this new value and it displays the previous one instead,
it means that the machine parameter table is locked.
To enter all 8 bits at once, proceed as follows:
*
If the parameter was selected by using the [RECALL] key, the CNC will blink
the first parameter bit (editing mode).
To quit this mode, press [CL] and the bit will stop blinking.
*
Press [CL] again and the bottom display will clear out.
*
Key in the desired value (series of 1s and 0s).
*
Press [ENTER] so this new value is "entered" in the machine parameter table.
If the CNC does not assume this new value and it displays the previous one instead,
it means that the machine parameter table is locked.
MACHINE PARAMETERS
Содержание 101
