38
English
English
Programming the coffee measures
How to access the programming function
To enter the programming mode, press push button (
18
)
and keep it pressed for a few seconds; the buzzer sounds
intermittently.
To exit the programming mode, after programming the
various drinks, press push button (
18
) again.
“ Before programming the coffee dispensing push
buttons fill the filter holder with the correct serving
of ground coffee. Don’t use coffee grouts for
programming servings.”
Fit and tighten the filter holder (
10
) on the coffee dispenser
unit, positioning the cup (or cups) under the nozzle (or nozzles)
of the filter holder (
10
).
Press (and keep momentarily pressed) the coffee dispensing
push button (
16, 17, 19
or
20
) corresponding to the required
serving to be programmed.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
Note: if you make a programming mistake, use a new dose
of ground coffee and repeat the operation.
!!!!!
Other hot beverage
Steam dispensing
Completely immerse the right or left steam nozzle (
6
) into the
container with the liquid to be heated and push the steam
control lever (
7
) upwards.
Wait until the liquid has reached the desired temperature,
then lower the steam command lever (
7
) to stop the issue of
steam.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows: turn the
nozzle towards the cup tray and carefully activate steam
dispensing at least once.
Heating milk for frothy coffee (cappuccino)
General indications
Milk is a delicate biological product and can easily deteriorate.
Heat modifies its structure. Milk must be kept at a storage
temperature
no higher than 5°C (41°F)
from the moment the
container is opened and throughout its entire period of use.
Our storage appliances are suitable for this purpose.
NOTE: at the end of the work day (or not more than 24 hours
from the time the container is opened), any remaining milk
must be discarded.
Use a tall narrow jug and fill it up to about the half-way mark.
Then plunge the steam jet pipe (
6
) into the milk.
Gradually open up the steam tap (
7
) and heat the milk for a
few seconds.
When the required amount of froth has been made and the
temperature is sufficiently high, stop the flow of steam by
turning knob (
7
) the other way (towards “0”).
When the steam jet pipe (
6
) is no longer required, clean it
thoroughly with a sponge and a clean cloth.
Dispensing hot water
Put a cup or other container under the hot water spout (
8
).
Lift lever (
9
) to dispense the desired amount of hot water.
Stop the dispensing by put lever (
9
) back into its original
position.
10
21
17
16
18
19
20
6
7
8
9
Содержание Smart A2-grp
Страница 4: ...4 SMART A R 18 21 20 17 19 16 15 1 4 10 7 6 7 9 2 8 6 2 14 3 12 11 10 23 22...
Страница 26: ...26...
Страница 34: ...42 English English...
Страница 42: ...82...
