![background image](http://html1.mh-extra.com/html/fadini/elpro-62/elpro-62_instruction-manual_537268015.webp)
pag 22
!
IMPORTANT: programming Junior is performed at first installation. Even in absence of mains power , programming is
stored for any changes in the position of slow programming can be performed by the same procedure.
Adjust the Trimmer Force necessary to move the gate. This adjustment also determines the strenght and impact resistance
with an obstacle in slowdown. An high force to inertia of the gate is leads to incorrect installation according to safety
regulation EN 12445 and EN 12453
=
=
PROGRAMMING AND SELF LEARNING OF THE OPERATION RUN
1° Operation:
unlock by opening until it stops ( beyond 90°), the unlocking handle with the coded key, freeing the gate from the Junior
ioperator, then position the gate at about half of its run. Recover the lock closing the handle as a safety measure, when the unlocking
handle is freed, the electrical power supply to the Elpro 62 PCB is disconnected
2° Operation:
Remove the electrical power supply to the electronic PCB by completely extracting the 230 v line fuse from its seat,
found on the front, underneath the Elpro 62 PCB.
Push and hold down the
P botton
and then afterwards install the line fuse. After 2-3 seconds release the P button: the LP LED will begin
to flash signalling theprogramming phase
+90°
LP
LP
3° Operation: learning of the run pattern and sowdowns.
It is possible to performe programming with the dedicated P button or else with an impulse from the coded transmitter.
It is important that both and stops, those for opening and closing, are installed. Position the magnetic or mechanical limit switches in
correspondence with the final opening and closing positions for the magnetic detector or for the Junior feeler.
Push with an impulse: the Junior
will begin to move the gate in
opening
LP
Beginning of the slowdown
Push with an impulse: the junior
will begin to slowdown until the
limit switch is detected
Push with an impulse: the Junior
move the in closing
Beginning of the slowdown
Push with an impulse : the Junior
will begin to slow down until the
limit switch is detected
3.1
3.2
3.3
3.4
3.2
3.3
3.4
FA
D
IN
I
normal speed
slowdown
slowdown
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Fig. 24
Programming end:
adjust the
Trimmer Force necessary to move
the gate
LP
LP
LP
LP
2-3 sec
LP
3.1
LP
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Fig. 29
-
+
-
+
Junior 624 - 24V dc
meccanica
FADINI
Elpro 62
GB
Содержание Elpro 62
