fadini Elpro 37DS, Руководство пользователя

Страница: 15 / 32

page 15
III II I
1 2 3 4
ON
OFF
DIP-SWITCH - B
30s 5s
0s 5min
T.FUN
1
2 3 4
ON
OFF
DIP-SWITCH - B
Operations
III II I
1 2 3 4
ON
OFF
DIP-SWITCH - B
-
+
T.FUN
0s - 3s
1
2 3 4
ON
OFF
DIP-SWITCH - B
For setting working time of the electric lock or courtesy lamp connected
to the 14-15 outputs, put the dip-switch B No.3 in ON and adjust the
working time by mean of trimmer T.FUN.
In this mode, the trimmer T.FUN enables you adjust electric lock working
time from 0s to 5s in the first half of trimmer travel. In the second half
of trimmer travel it allows you connect a relay to 14-15 outputs for a
courtesy lamp working time control, adjustable from 30s to 5 min.
Once the electric lock or courtesy lamp working time is set, put all
dip-switches B in OFF.
To set the additional stop time after braking it is necessary to put the
dip-switch B No.2 in ON and adjust the stop time by mean of trimmer
T.FUN.
Once the calibration of additional stop time is completed put all
Dip-switches B in OFF.
N.W.: this function is enabled and adjustable even if the electronic
brake is disabled. It allows more time for the gate to reverse the
travel direction when safety devices as photocells or sensitive edges
are engaged, so as proper reverse movement is achieved, especially
for single-phase motors where high inertia is involved.
Operations
Additional stop
time after braking
when safety
devices are
activated:
III II I
1 2 3 4
ON
OFF
DIP-SWITCH - B
-
+
T.FUN
0s - 2s
1
2 3 4
ON
OFF
DIP-SWITCH - B
To adjust the braking duration it is necessary to put the dip-Switch B
No.1 in ON and set the braking time by Trimmer T.FUN.
Once the calibration of braking duration is completed, put all
Dip-switches B in OFF.
Dip - switch and trimmer of functions
Description
ELECTRONIC BRAKE FUNCTION
Electric lock:
14 15
12Vac power supply output
for
electric lock 15VA max or
relè for courtesy lamp control
or courtesy lamp:
ATTENTION:
In cases a motor with mechanical brake is used or a control board ELPRO 14 is replaced, the DIP-switch-A
No.12 has to be in OFF.
!
To enable the electronic brake function set the dip-switch-A No. 12
in ON and adjust the electronic brake intensity by means of the the selector in the figure.
The factory preset adjustments are suitable for most installations.
For a more precise regulation of the electronic brake, it is possible to set up various braking
parameters by following the
advanced instructions bellow .
ELECTRONIC BRAKE
INTENSITY
1 2 4 5 3
ON
OFF
1 2 3 4 5 6 7 8 9 10 11
12
DIP-SWITCH - A
Operations
Dip - switch and trimmer of functions
Function
ADVANCED INSTRUCTIONS FOR THE ELECTRONIC BRAKE
ATTENTION: the electronic brake is to be enabled by putting the dip-switch No.12 in ON.
Description
Braking time:
SINGLE – THREE PHASE ELECTRONIC CONTROL BOARD WITH ELECTRONIC BRAKE FOR
DOUBLE-LEAF SLIDING GATE AUTOMATIC SYSTEMS WITH OR WITHOUT LIMIT SWITCHES
meccanica
FADINI
GB
37
DS