EN
INSTALLATION MANUAL AND INSTRUCTIONS FOR USE
18
C. Installation guide
•
Make sure the towel rail is not leaking.
•
The towel rack should always be placed with the control on the bottom.
•
The towel rail will not be placed directly on top of an electrical outlet.
•
Avoid water jets hitting the equipment.
•
Make sure that the mains voltage is the same as indicated in the technical specification.
•
When installing in a room with a bath or shower, respect the “protection zones” indicated in the
RBT (in the United Kingdom according to the IEE cable directives). In addition, you must respect
all local security directives.
•
The device must be protected by a 30mA differential circuit breaker
•
For models that do not have a plug, it is necessary to install a suitable omnipolar switch to ensure
complete disconnection if necessary.
•
WARNING! Do not rotate the device more than 30º in both directions.
•
Connect the energy cable.
D. Wall fixing
See diagram on the last page of this manual.
•
Remove the protective caps from the ends.
•
Place the heated towel rail against the wall in the desired position.
•
Using a pencil, mark their position on the wall around the support tubes. Make sure there is no
wiring in the wall where you will be drilling.
•
With the help of a suitable drill and bit, drill the holes in the tile / wall to the required depth.
•
Important: the holes must be drilled correctly aligned and suitable for the diameter of the plug
and the length of the wall anchor screws.
•
Insert the fixing plugs into the holes using a screwdriver. Repeat the procedure for each heated
towel rail attachment bracket.
•
Mount the heated towel rail once you have fixed the plugs in the desired place, then tighten the
brackets with the anchor screws.
E. Warranty
In the event of any incident during the warranty period, contact our Technical Assistance Service
(contact indicated on the back cover of this manual).
The company offers a technical guarantee for the period of 2 years. The manufacturer guarantees
that this product does not present any material, design or manufacturing defect at the time of pur-
chase.
