www.factorelectronics.com
Rear Panel Operations and Connections
VOX SENS
– This rotary control adjusts the sensitivity of the override
circuit. Turning the VOX SENS control clockwise triggers the auto
sensing circuit on weaker input signals. Turning the VOX SENS control
counter clockwise triggers the auto sensing circuit on stronger input
signals. This control will function only when the PRIORITY #4 dipswitch
is ON. Start at the 12:00 position. If the override cuts in and out when
there is no page signal present (called false triggering) then reduce
the SENS by turning counter clockwise. If the leading edge of the page
is cut off increase the sensitivity by turning the SENS control
clockwise.
DIP SWITCH 1
24v PHT – This switch applies 24v to the + and – pins
of the terminal block BALANCED jack. This feature provides phantom
power for condenser microphones. NOTE: always set the 24v PHT
dipswitch UP or OFF if a line level source or dynamic microphone
source is connected where phantom power is not needed.
DIP SWITCH 2
MIC/LINE – This switch adjusts the sensitivity of the
terminal block BALANCED jack between microphone level signals and
line level signals. Set the switch up for line level and down for
microphones. Note: line level sources will overload the BALANCED
input if the dipswitch is set to MIC. If the dipswitch is set to LINE and a
microphone is connected the input level will be too low. Always make
sure this dipswitch is set appropriately for the device that is
connected.
